Pro-Line Throttle Body Cleaner 400 ml

Special active solvent for cleaning typical dirt and deposits in the intake and throttle valve area. Dissolves and removes contaminants such as oil, resin, adhesive, etc. Also reliably cleans nozzles and internal parts. Ensures the functionality of moving parts and increases the operational reliability of gasoline-powered engines.

For the intake and throttle valve area, including nozzles and bores. For use in gasoline engines only!

Create direct access to the throttle valve. Start the engine to begin cleaning.

Spray throttle valve cleaner onto the entire throttle valve area using the spray probe at short intervals of 2-3 seconds at a minimum of 2,000 rpm.

If the engine cannot maintain its speed or cannot be started with the intake manifold disconnected, disconnect the connector from the mass air flow sensor with the ignition off. In this case, the stored error must be deleted from the engine control unit after cleaning using a suitable diagnostic tool, and the air mass sensor must be re-trained if necessary.

If a speed fluctuation of more than 1,000 rpm occurs during use, it is important to shorten the spray intervals. Note that the throttle valve cleaner must not come into contact with the air mass sensor or painted components.

For stubborn deposits on the throttle valve, in the intake manifold, or on the intake valves, cleaning can be repeated with a second can. After use, run the engine for approximately 20 seconds at a minimum of 2,000 rpm to burn off any residue remaining in the intake system.